Autoclave Quote Request
TEC logo-Header


Autoclave Quote Request

The form provides many of the options which affect price and performance. If you have additional questions or require further assistance, please contact us at

Contact Information

Will the Autoclave be installed at this location? 

Type of quotation? 

Quotation required by date?  

Anticipated Equipment On-Line Date?  

Dimensions and Capacity

Internal Working Diameter? 

Internal Working Length? 

Maximum Pressure Capability? 

Maximum Temperature Capability? 

Pressure System is by others - customer supplied or customer leased equipment is required.

Pressurization source gas to be used? 

Average maximum rate required for pressurization? 

Average maximum rate required for depressurization? 

Proper fan circulation is important to guaranteeing good temperature uniformity as well as improved part heat transfer.

Required temperature uniformity after autoclave temperature reaches steady-state conditions:


Number of part temperature thermocouples:  
Thermocouple type:  

Part and Tool Load Selection

To properly size the heater and cooling systems for the autoclave, we must know what your typical load would be.

What is the part and tool load to be used for heating and cooling calculations:


Internal Autoclave Cart required?  

Floor Transfer Cart required?  

Is the autoclave to be mounted in a pit with a bridge required?  

Heating System

The heating rate is the average air temperature rate from ambient to max. temperature, when the autoclave is loaded and at maximum working pressure.

Maximum heating rate required?    

Heating Method: 

Cooling System

Maximum cooling rate is required?  

Provide your local wet bulb temperature, if known: 

The autoclave can include an independent cooling system or it can utilize your plant's existing water system either with or without a heat exchanger.

Please select from the following options: 

Note: Included in all above options are appropriately sized cooling control components for a fully operational system

Cooling Coil Material? 

Cooling System Plumbing Material? 

Vacuum System

Please indicate below if you want TEC to quote a vacuum pump(s) for this autoclave:

Other Information: 

Do you need vacuum header level control?

How many vacuum source lines are required?  

How many vacuum probe lines are required?  

Please select which type of monitoring is required:

Do you want automatic vacuum source line control?

Please indicate if Resin Traps are desired: 

Oxygen Monitoring and Purge Systems

Installation, Startup and Training Options

TEC can provide a turnkey autoclave, including installation, startup, and training. Customer will provide rigging and transportation from TEC to site.

Please select from the following options:

Additional Information